Want to trade brass

[sgt_murf]

brian,, You may be oversizing the brass , by a lot ! it's been spoke of here before. You are pushing the entire center of the brass downward. Unscrew the die and start over, with contact to the die with the Ram all the way up then try 1 in yo chamber, then screw the die in a tiny bit at a time till you get it to cycle, have patience .... then add a million'th more , lock it down. Load up a dummy round== no primer, no powder and try to cycle that 1 thru. Have you ever done this before? Reloading , that is ?

+1
I think sneaky is dead on Laupla has worked beautifully in my rifle / dies, If I had any honady I'd swap in a heatbeat