6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel ARs and Other Semi-Autos v
What is the best way to break in the Hi Cap mags??

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
What is the best way to break in the Hi Cap mags??
gophernuts
Unregistered
 
#4
07-31-2011, 01:43 AM
I hear ya for sure. I just wish the mags didn't suck quite so terribly, because they do. After some sanding on the follower it works a little bit better. I'm going to bead blast them and cerakote them and hopefully that will improve the lubricity a bit. Anybody every try doing that? I did it with a few .223 mags just to get uses to doing it and it worked amazingly well so I expect the same results.
Reply


Messages In This Thread
What is the best way to break in the Hi Cap mags?? - by gophernuts - 07-30-2011, 10:11 PM
What is the best way to break in the Hi Cap mags?? - by warped - 07-30-2011, 10:26 PM
What is the best way to break in the Hi Cap mags?? - by gophernuts - 07-31-2011, 01:43 AM
What is the best way to break in the Hi Cap mags?? - by RangerRick - 07-31-2011, 02:07 AM
What is the best way to break in the Hi Cap mags?? - by StoneTower - 07-31-2011, 04:18 PM
What is the best way to break in the Hi Cap mags?? - by StoneTower - 07-31-2011, 06:16 PM
What is the best way to break in the Hi Cap mags?? - by StoneTower - 07-31-2011, 07:43 PM
What is the best way to break in the Hi Cap mags?? - by mtn_shooter - 07-31-2011, 08:50 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)