6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Troubleshooting v
Not ejecting properly

Linear Mode
Not ejecting properly
Drifter Offline
Posting Freak
*****
Posts: 1,685
Threads: 55
Joined: Mar 2011
#3
07-26-2011, 04:46 AM (This post was last modified: 07-26-2011, 06:42 AM by Drifter.)
It might be overgassed if it's a midlength system. My suggestion is to try an adjustable gas block.

I've used the PRI gas block on two different 18" midlength barrels. I shut the system off, then backed the screw out one quarter of one turn. Both run great now.

Buffers, springs, different weight carriers, etc work fine for tuning a setup that's already close to ideal. But they simply treat the symptoms if the problems are severe.
Drifter
Find
Reply


Messages In This Thread
Not ejecting properly - by Sinster - 07-26-2011, 12:05 AM
Not ejecting properly - by warped - 07-26-2011, 03:59 AM
Not ejecting properly - by Drifter - 07-26-2011, 04:46 AM
Not ejecting properly - by LRRPF52 - 07-26-2011, 01:51 PM
Not ejecting properly - by Sinster - 07-26-2011, 07:32 PM
Not ejecting properly - by warped - 07-26-2011, 08:03 PM
Not ejecting properly - by LRRPF52 - 07-26-2011, 10:50 PM
Not ejecting properly - by Sinster - 08-02-2011, 12:15 AM
Not ejecting properly - by wolverine - 08-12-2011, 02:24 AM
Not ejecting properly - by LR1955 - 08-12-2011, 12:40 PM
Not ejecting properly - by davidj - 08-12-2011, 02:15 PM
Not ejecting properly - by wolverine - 08-13-2011, 05:13 PM
Not ejecting properly - by LR1955 - 08-13-2011, 06:24 PM
Not ejecting properly - by bwaites - 08-13-2011, 07:01 PM
Not ejecting properly - by wolverine - 08-16-2011, 04:16 AM
Not ejecting properly - by LR1955 - 08-16-2011, 11:51 AM
Not ejecting properly - by StoneTower - 08-16-2011, 04:35 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)