09-12-2013, 01:01 AM
The tool from Brownells works well, I changed the ejector in my bolt that was jamming rounds into the feed ramps, and now the gun feeds perfectly. I replaced my ejector with a new on that did not have any machining marks on it, but when I get an extractor for my stripped Grendel Bolt, I'll mod the ejector before I install it. Thanks for the great tip!
wheelguner Wrote:Another tidbit from Accurate Shooter:
http://bulletin.accurateshooter.com/2013...artridges/
This is a mod that I have been doing because as a mechanical designer and machinist I hate sharp edges. I hadn't considered this benefit having never experienced the problem since I always do this as soon as I get a new AR.
Thought you all might find it of interest.