6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Military & Law Enforcement v
Lets start over: how do you design a GPC?

Linear Mode
Lets start over: how do you design a GPC?
Tony Williams
Unregistered
 
#33
07-02-2013, 06:18 AM
Nammo Lapua has developed a second-generation 5.56mm "green" round using a steel-cored FMJ bullet (matching all Hague/Geneva interpretations) which they claim matches M855 ballistics, yaws rapidly and reliably on impact, and penetrates better.
Reply


Messages In This Thread
Lets start over: how do you design a GPC? - by Trooper - 06-29-2013, 10:14 PM
Lets start over: how do you design a GPC? - by JDub - 06-30-2013, 12:59 AM
Lets start over: how do you design a GPC? - by JASmith - 06-30-2013, 02:24 AM
Lets start over: how do you design a GPC? - by Tony Williams - 06-30-2013, 02:50 AM
Lets start over: how do you design a GPC? - by LRRPF52 - 06-30-2013, 05:31 AM
Lets start over: how do you design a GPC? - by LRRPF52 - 06-30-2013, 05:35 AM
Lets start over: how do you design a GPC? - by Trooper - 06-30-2013, 07:06 AM
Lets start over: how do you design a GPC? - by LRRPF52 - 06-30-2013, 05:55 PM
Lets start over: how do you design a GPC? - by JASmith - 06-30-2013, 11:09 PM
Lets start over: how do you design a GPC? - by LRRPF52 - 07-01-2013, 07:08 PM
Lets start over: how do you design a GPC? - by woohoo - 07-01-2013, 08:28 PM
Lets start over: how do you design a GPC? - by Tony Williams - 07-02-2013, 06:18 AM
Lets start over: how do you design a GPC? - by Trooper - 07-02-2013, 10:43 AM
Lets start over: how do you design a GPC? - by woohoo - 07-02-2013, 01:58 PM
Lets start over: how do you design a GPC? - by Guardsman26 - 07-09-2013, 05:17 PM
Lets start over: how do you design a GPC? - by LRRPF52 - 07-09-2013, 05:52 PM
Lets start over: how do you design a GPC? - by LRRPF52 - 07-09-2013, 07:25 PM
Lets start over: how do you design a GPC? - by JASmith - 07-09-2013, 11:10 PM
Lets start over: how do you design a GPC? - by JASmith - 07-10-2013, 03:35 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)