04-25-2013, 10:43 PM
There are threads on this forum explaining the procedure. There was a good thread at sniperhide forum I believe that was posted on this forum that was very good at explaining the method. It had pictures that made it easy to follow. Maybe someone else here can find it or help. First I remove the extractor and ejector . I then found two buffing wheels for my dremel tool and glued one on top of the other . They fit perfectly in the bolt where the cartridge base sits in the bolt. I use red jeweler buffing compound and buff the in side of the bolt and very lightly buff the outside of the bolt rim. It comes out very shiny and smooth. I then lightly buff the ends and beveled part of the extractor to smooth it up.. I test it with an empty case to see if any thing drags or hooks on the case. This is hard for me to explain without pictures. Maybe someone else on this forum could explain it better. You want to be careful not to take too much off when polishing.