06-23-2011, 05:35 PM
Gunworm,
I just looked at your setup. You have Sundevil receivers, An MI 15" handguard, a LaRue mount, Geissele, and a NightForce. Those components should add up to a whole ton of success.
I would start by checking your scope mount. Are the bottom scope ring screws on the LaRue tight, then check the top ones? Are the torque nuts on the LaRue QD levers tight enough and evenly tight?
Is the MI barrel nut tight? Is your gas block tight?
With the components you have, there should be nothing wrong with your accuracy. That rifle should be drilling holes. If you were shooting on high magnification, dial down to 10x for your 100yd groups, and maintain the exact point of aim at the center of your target throughout the process of shooting. I don't know if I'm insulting your shooting experience, but these are the areas I would look at. I apologize in advance if you are a highly-experienced shooter, and I just told you how to tie your shoes...
Let us know how those checks go, and see if any of that helps.
LRRPF52
I just looked at your setup. You have Sundevil receivers, An MI 15" handguard, a LaRue mount, Geissele, and a NightForce. Those components should add up to a whole ton of success.
I would start by checking your scope mount. Are the bottom scope ring screws on the LaRue tight, then check the top ones? Are the torque nuts on the LaRue QD levers tight enough and evenly tight?
Is the MI barrel nut tight? Is your gas block tight?
With the components you have, there should be nothing wrong with your accuracy. That rifle should be drilling holes. If you were shooting on high magnification, dial down to 10x for your 100yd groups, and maintain the exact point of aim at the center of your target throughout the process of shooting. I don't know if I'm insulting your shooting experience, but these are the areas I would look at. I apologize in advance if you are a highly-experienced shooter, and I just told you how to tie your shoes...
Let us know how those checks go, and see if any of that helps.
LRRPF52