6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Troubleshooting v
Another failure to chamber thread.... help please

Linear Mode
Another failure to chamber thread.... help please
Rootshot
Unregistered
 
#27
06-20-2011, 01:54 PM
I'm going to agree with glane5910 that it appears a gas issue. Check the gas block alignment to the gas port. If you remove the gas block, you should see a carbon stain on the barrel (at least on stainless) that indicates where the gas block hole is. Also make sure the gas tube is straight. I've also heard (not verified) that if the gaps in the gas rings on the bolt are aligned (they shouldn't be), it can cause cycling issues.

--Rootshot
Reply


Messages In This Thread
Another failure to chamber thread.... help please - by ss355 - 05-09-2011, 03:40 PM
Another failure to chamber thread.... help please - by Rootshot - 05-09-2011, 04:48 PM
Another failure to chamber thread.... help please - by warped - 05-09-2011, 09:19 PM
Another failure to chamber thread.... help please - by fanofflyn - 05-09-2011, 11:00 PM
Another failure to chamber thread.... help please - by fanofflyn - 05-09-2011, 11:33 PM
Another failure to chamber thread.... help please - by Rootshot - 05-10-2011, 04:05 AM
Another failure to chamber thread.... help please - by rushmc - 05-10-2011, 02:09 PM
Another failure to chamber thread.... help please - by fanofflyn - 05-13-2011, 10:04 PM
Another failure to chamber thread.... help please - by rushmc - 05-19-2011, 11:49 AM
Another failure to chamber thread.... help please - by warped - 05-19-2011, 12:47 PM
Another failure to chamber thread.... help please - by warped - 05-19-2011, 01:26 PM
Another failure to chamber thread.... help please - by Airhog - 05-21-2011, 03:43 PM
Another failure to chamber thread.... help please - by robsf49ers - 05-22-2011, 08:57 PM
Another failure to chamber thread.... help please - by robsf49ers - 05-23-2011, 03:45 AM
Another failure to chamber thread.... help please - by fanofflyn - 05-24-2011, 03:15 AM
Another failure to chamber thread.... help please - by Airhog - 05-25-2011, 04:07 AM
Another failure to chamber thread.... help please - by fanofflyn - 05-30-2011, 05:55 PM
Another failure to chamber thread.... help please - by glane5910 - 06-15-2011, 05:49 PM
Another failure to chamber thread.... help please - by glane5910 - 06-15-2011, 05:51 PM
Another failure to chamber thread.... help please - by glane5910 - 06-20-2011, 01:03 PM
Another failure to chamber thread.... help please - by Rootshot - 06-20-2011, 01:54 PM
Another failure to chamber thread.... help please - by glane5910 - 06-20-2011, 02:18 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)