02-08-2013, 04:27 PM
Tikka - in my experiences, there are usually 3 things that may cause this -
1) Mic your firing pin with calipers to ensure it is within specs (these sometimes get blunted)
2) Check primers on reloaded rounds to make sure they were not seated too deeply
3) Check hammer spring (may be week/assembled improperly)
Re the gunk - where was it located in BCG?
1) Mic your firing pin with calipers to ensure it is within specs (these sometimes get blunted)
2) Check primers on reloaded rounds to make sure they were not seated too deeply
3) Check hammer spring (may be week/assembled improperly)
Re the gunk - where was it located in BCG?
I have never made but one prayer to God, a very short one: 'O Lord, make my enemies ridiculous.' And God granted it.
- Voltaire
- Voltaire