6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Troubleshooting v
Not chambering!!

Linear Mode
Not chambering!!
GregP42
Unregistered
 
#15
06-18-2011, 12:15 AM
I have a strange question, I was working with a fired piece of brass last night and it would not chamber easily, and when I could get it to chamber I just about had to use a mallet on the charging handle to get it back out. Is that normal to do that??

Thanks,
Greg
Reply


Messages In This Thread
Not chambering!! - by Oobray - 06-05-2011, 04:31 AM
Not chambering!! - by bwaites - 06-05-2011, 04:36 AM
Not chambering!! - by LR1955 - 06-05-2011, 12:23 PM
Not chambering!! - by RStewart - 06-05-2011, 12:46 PM
Not chambering!! - by Oobray - 06-05-2011, 04:45 PM
Not chambering!! - by bwaites - 06-05-2011, 05:31 PM
Not chambering!! - by ol_goat - 06-05-2011, 06:01 PM
Not chambering!! - by warped - 06-06-2011, 03:50 PM
Not chambering!! - by warped - 06-06-2011, 03:53 PM
Not chambering!! - by glane5910 - 06-14-2011, 05:30 AM
Not chambering!! - by LR1955 - 06-14-2011, 12:07 PM
Not chambering!! - by warped - 06-14-2011, 03:33 PM
Not chambering!! - by glane5910 - 06-14-2011, 03:36 PM
Not chambering!! - by Longshot_34 - 06-14-2011, 03:41 PM
Not chambering!! - by GregP42 - 06-18-2011, 12:15 AM
Not chambering!! - by LRRPF52 - 06-18-2011, 01:32 AM
Not chambering!! - by glane5910 - 06-18-2011, 01:42 AM
Not chambering!! - by GregP42 - 06-18-2011, 05:10 AM
Not chambering!! - by glane5910 - 06-18-2011, 05:16 AM
Not chambering!! - by glane5910 - 06-18-2011, 05:19 AM
Not chambering!! - by GregP42 - 06-18-2011, 06:20 AM
Not chambering!! - by LRRPF52 - 06-18-2011, 06:25 AM
Not chambering!! - by z06man - 06-18-2011, 06:31 AM
Not chambering!! - by PA_Allen - 06-18-2011, 02:06 PM
Not chambering!! - by glane5910 - 06-18-2011, 02:18 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)