Homemade Steel Target Help

[Variable]

I use either old firehose, or conveyer belt material to hang the targets from the mounting system. Some of the easiest mounting system is half inch re-bar cut to about 5 foot lengths. Use two half inch 90 degree plumbing elbows with about 5 inch nipples on each side. Pound the two end pieces of re-bar into the ground, then stick the cross piece into the pipe nipples, and put the other end of the nipples that come out of the 90 degree elbows onto the pieces of re-bar you pounded into the ground.

If you want sturdier mounts, use five-eighths re-bar, and three quarter inch pipe fittings. You can combine pipe and re-bar fittings by using 90 elbows that are half inch on one end, and three quarter inch on the other end. That way, you have a five eighths inch thick cross piece. If you want it even sturdier, put the cross piece inside a piece of pipe.

Any pics of your pvc/rebar fitting combo? I'm trying to figure that one out in my mind, and being plumb(ing) dumb, I'm not sure which exact pieces you are talking about.