6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Troubleshooting v
Feeding problem - Please help

Linear Mode
Feeding problem - Please help
hughmongus
Unregistered
 
#6
11-29-2012, 11:22 AM
I removed the barrel yesterday. The feed ramps had awful tooling marks on them. I sanded the feed ramps until the tooling marks were gone then buffed them to chrome like finish with a dremel. I fired 10 rounds through it yesterday and it cycled every round.

[Image: photo4.jpg]
Reply


Messages In This Thread
Feeding problem - Please help - by hughmongus - 11-28-2012, 12:34 AM
Feeding problem - Please help - by ricsmall - 11-28-2012, 01:28 AM
Feeding problem - Please help - by hughmongus - 11-28-2012, 01:32 AM
Feeding problem - Please help - by Bwild97 - 11-28-2012, 03:44 AM
Feeding problem - Please help - by sneaky one - 11-29-2012, 01:25 AM
Feeding problem - Please help - by hughmongus - 11-29-2012, 11:22 AM
Feeding problem - Please help - by ricsmall - 11-29-2012, 11:23 AM
Feeding problem - Please help - by kamrr4437 - 11-29-2012, 12:15 PM
Feeding problem - Please help - by txgunner00 - 11-29-2012, 01:13 PM
Feeding problem - Please help - by Bwild97 - 11-29-2012, 03:47 PM
Feeding problem - Please help - by hughmongus - 11-29-2012, 11:38 PM
Feeding problem - Please help - by hughmongus - 11-29-2012, 11:38 PM
Feeding problem - Please help - by sneaky one - 11-30-2012, 01:24 AM
Feeding problem - Please help - by ericv - 11-30-2012, 01:29 AM
Feeding problem - Please help - by hughmongus - 11-30-2012, 09:12 AM
Feeding problem - Please help - by sneaky one - 12-01-2012, 02:21 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)