06-01-2011, 08:28 AM
DARKOP, I WILL check the spring under the disconnector. I have built a few AR's but hey,,,, you never know. I will post results. It does seem like a LPK problem.
I loaded some brass with primers and "dropped" the bolt on the brass. I know that this is bad and can break the bolt but I needed to see if the firing pin had that much play...... I even cut a primer pocket .010" deep and set a primer up at .016" to see the indention on the primer. The firing pin is not the culprit.....the indention was the same with the .006" as with the .016" primer.
LRRPF52: The brass flew very nicely. It all ejected very uniformely, going to the same place. I feel that this is not an issue, but thank you for the variable.....
LHClarke
I loaded some brass with primers and "dropped" the bolt on the brass. I know that this is bad and can break the bolt but I needed to see if the firing pin had that much play...... I even cut a primer pocket .010" deep and set a primer up at .016" to see the indention on the primer. The firing pin is not the culprit.....the indention was the same with the .006" as with the .016" primer.
LRRPF52: The brass flew very nicely. It all ejected very uniformely, going to the same place. I feel that this is not an issue, but thank you for the variable.....
LHClarke