16" Grendel at 200yds w/123gr AMAX Factory
|
16" Grendel at 200yds w/123gr AMAX Factory
|
|
10-30-2012, 07:48 PM
hydrotech Wrote:are all the loads you guys use for 16" grendels mag fed? not single feed? I always heard from my fclass buddies that Amaxes like to be close to the lands. So are your amaxes maglength and jumping quite a bit? All I run are mag-fed loads. There isn't a lot of jump because of the compound throat angle. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
16" Grendel at 200yds w/123gr AMAX Factory - by LRRPF52 - 10-22-2012, 02:11 AM
16" Grendel at 200yds w/123gr AMAX Factory - by ricsmall - 10-22-2012, 10:48 AM
16" Grendel at 200yds w/123gr AMAX Factory - by LRRPF52 - 10-22-2012, 02:12 PM
16" Grendel at 200yds w/123gr AMAX Factory - by hydrotech - 10-22-2012, 07:51 PM
16" Grendel at 200yds w/123gr AMAX Factory - by LRRPF52 - 10-22-2012, 10:35 PM
16" Grendel at 200yds w/123gr AMAX Factory - by hydrotech - 10-23-2012, 03:51 PM
16" Grendel at 200yds w/123gr AMAX Factory - by Drifter - 10-23-2012, 04:28 PM
16" Grendel at 200yds w/123gr AMAX Factory - by LRRPF52 - 10-30-2012, 07:48 PM
16" Grendel at 200yds w/123gr AMAX Factory - by Deezil - 10-30-2012, 08:48 PM
16" Grendel at 200yds w/123gr AMAX Factory - by Lead Chucker - 12-11-2012, 02:44 AM
16" Grendel at 200yds w/123gr AMAX Factory - by LRRPF52 - 12-11-2012, 03:53 AM
16" Grendel at 200yds w/123gr AMAX Factory - by Lead Chucker - 12-11-2012, 05:43 PM
16" Grendel at 200yds w/123gr AMAX Factory - by VASCAR2 - 12-12-2012, 02:38 AM
|