6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Troubleshooting v
Not extracting empty brass

Linear Mode
Not extracting empty brass
VASCAR2 Offline
Posting Freak
*****
Posts: 6,206
Threads: 50
Joined: Mar 2011
#2
10-29-2012, 03:45 AM
If a rifle fails to extract check the gas tube and gas block alignment. Insufficient gas will cause a round to fail to extract. Inspect the extractor for the grip on the brass. Some extractors have burrs which will mar the brass and hinder the spent case from being kicked out of the chamber. I'd also inspect the bolt, gas rings and bolt carrier. Ensure there is no gas leakage around the carrier key.

I 'm sure others will chime in.
Find
Reply


Messages In This Thread
Not extracting empty brass - by invisiman - 10-29-2012, 02:49 AM
Not extracting empty brass - by VASCAR2 - 10-29-2012, 03:45 AM
Not extracting empty brass - by quadfather03 - 10-29-2012, 03:53 AM
Not extracting empty brass - by Dogue - 10-29-2012, 12:12 PM
Not extracting empty brass - by txgunner00 - 10-29-2012, 12:12 PM
Not extracting empty brass - by invisiman - 10-29-2012, 12:35 PM
Not extracting empty brass - by davidj - 10-29-2012, 04:20 PM
Not extracting empty brass - by nboost - 10-29-2012, 04:52 PM
Not extracting empty brass - by Drifter - 10-29-2012, 07:16 PM
Not extracting empty brass - by davidj - 10-29-2012, 09:49 PM
Not extracting empty brass - by LRRPF52 - 10-29-2012, 10:50 PM
Not extracting empty brass - by rasp65 - 10-29-2012, 10:55 PM
Not extracting empty brass - by LRRPF52 - 10-29-2012, 11:13 PM
Not extracting empty brass - by Bill Alexander - 10-29-2012, 11:38 PM
Not extracting empty brass - by hill.brandonj - 10-30-2012, 02:27 AM
Not extracting empty brass - by invisiman - 10-30-2012, 02:07 PM
Not extracting empty brass - by txgunner00 - 10-31-2012, 12:10 AM
Not extracting empty brass - by invisiman - 10-31-2012, 01:59 AM
Not extracting empty brass - by davidj - 10-31-2012, 04:25 AM
Not extracting empty brass - by rasp65 - 10-31-2012, 11:27 AM
Not extracting empty brass - by davidj - 10-31-2012, 04:25 PM
Not extracting empty brass - by rasp65 - 10-30-2012, 12:44 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)