6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Troubleshooting v
Fail to Feed

Linear Mode
Fail to Feed
LRRPF52
Unregistered
 
#12
10-01-2012, 04:16 PM
You can just radius the ejector pin. It is the pin opposite of the extractor, which is also spring-driven axially. If the ejector has a sharp edge on it, it is likely to arrest the side of the rim of the case, resulting in the situation posted by 03Cobra.
Reply


Messages In This Thread
Fail to Feed - by lawman106 - 04-07-2012, 12:55 AM
Fail to Feed - by Lead Chucker - 04-07-2012, 03:05 AM
Fail to Feed - by fanofflyn - 04-07-2012, 01:53 PM
Fail to Feed - by terrywick4 - 05-13-2012, 04:15 PM
Fail to Feed - by chuy - 09-25-2012, 02:36 PM
Fail to Feed - by rasp65 - 09-25-2012, 10:42 PM
Fail to Feed - by LRRPF52 - 09-26-2012, 04:38 AM
Fail to Feed - by chuy - 09-26-2012, 09:02 PM
Fail to Feed - by LRRPF52 - 09-26-2012, 10:06 PM
Fail to Feed - by 03cobra - 10-01-2012, 12:37 PM
Fail to Feed - by rasp65 - 10-01-2012, 03:03 PM
Fail to Feed - by LRRPF52 - 10-01-2012, 04:16 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)