Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Question about WCI break...
#8
There are many variants of loctite, IIRC the highest teperature one is black or was, it releases at 450F

There are very few cases of loosening, it only takes a minute to check or correct if so.

Never chase your threads with a die, clean with a brass brush or just use the brake to clean it up.

The brake has more precise threads than that of most all dies.

Like I said, I have shot until my bbl was smoking hot and still needed a rod inserted to remove the brake.

Of course there can be very small differences in others threads and also how hard they tightened in the first place.

Please never use a washer or crush washer, that was not how this was designed to be used.

It could also lead to a misalignment, the face inside the brake mates with the crown ensuring a proper alignment, the threads alignment is good but only a backup to the crown/face.

This is why a WCI is so well fitted, you will note that nearly all other muzzle devices do not fit like this.

In the case of a A2 or similar if they did not have a crush washer it would fall right off they fit so loosely.
Reply


Messages In This Thread
Question about WCI break... - by gophernuts - 05-26-2011, 01:25 AM
Question about WCI break... - by ARMANIAC - 05-26-2011, 02:04 AM
Question about WCI break... - by JohnOD - 05-26-2011, 03:00 AM
Question about WCI break... - by warped - 05-26-2011, 03:06 AM
Question about WCI break... - by kamrr4437 - 05-26-2011, 03:38 AM
Question about WCI break... - by warped - 05-26-2011, 02:09 PM
Question about WCI break... - by z06man - 05-28-2011, 08:36 AM
Question about WCI break... - by warped - 05-28-2011, 09:40 AM
Question about WCI break... - by warped - 05-28-2011, 09:50 AM
Question about WCI break... - by JohnOD - 05-28-2011, 04:06 PM
Question about WCI break... - by kamrr4437 - 05-28-2011, 06:26 PM
Question about WCI break... - by mtn_shooter - 05-28-2011, 06:52 PM
Question about WCI break... - by warped - 05-29-2011, 01:46 AM
Question about WCI break... - by wakerider - 05-29-2011, 05:53 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)