09-25-2012, 01:40 PM
Bob-
Since you've indicated in the past that the attention to details in the loading process is a contributor to your consistently positive results, do you find runout and/or neck concentricity factors to same or best addressed in die setup? I'm more than occasionally frustrated with wide disparity of one or both, even when trying to pay particular attention when sizing brass. Using Redding FL comp dies with 288 bushing. Some runout .001 or less, the next piece can be out by .005, without any seeming variation in technique. Your comments welcome.
Since you've indicated in the past that the attention to details in the loading process is a contributor to your consistently positive results, do you find runout and/or neck concentricity factors to same or best addressed in die setup? I'm more than occasionally frustrated with wide disparity of one or both, even when trying to pay particular attention when sizing brass. Using Redding FL comp dies with 288 bushing. Some runout .001 or less, the next piece can be out by .005, without any seeming variation in technique. Your comments welcome.
