6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Troubleshooting v
Fail to Feed

Linear Mode
Fail to Feed
rasp65 Offline
Senior Member
****
Posts: 667
Threads: 19
Joined: Mar 2011
#6
09-25-2012, 10:42 PM
Chuy There is some confusion by the OP. He talks about having problems with the "ejector" but he is clearly describing the extractor. It is much easier to start with the extractor because the pin pushes out easy whereas the ejector uses a roll pin through the side of the bolt.
Find
Reply


Messages In This Thread
Fail to Feed - by lawman106 - 04-07-2012, 12:55 AM
Fail to Feed - by Lead Chucker - 04-07-2012, 03:05 AM
Fail to Feed - by fanofflyn - 04-07-2012, 01:53 PM
Fail to Feed - by terrywick4 - 05-13-2012, 04:15 PM
Fail to Feed - by chuy - 09-25-2012, 02:36 PM
Fail to Feed - by rasp65 - 09-25-2012, 10:42 PM
Fail to Feed - by LRRPF52 - 09-26-2012, 04:38 AM
Fail to Feed - by chuy - 09-26-2012, 09:02 PM
Fail to Feed - by LRRPF52 - 09-26-2012, 10:06 PM
Fail to Feed - by 03cobra - 10-01-2012, 12:37 PM
Fail to Feed - by rasp65 - 10-01-2012, 03:03 PM
Fail to Feed - by LRRPF52 - 10-01-2012, 04:16 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)