Today was like Christmas
|
Today was like Christmas
|
|
07-04-2012, 11:02 AM
This might be a stupid question but how do you mount a set screw gas block? I'm on my FIRST build. There are no little indents or holes for the set screws in my barrel. Do you use a jig or something to line up the port and drill two indents? Or do you just crank the hell out of the set screws and hope for the best? I wanted the clamp on so I could avoid the issue. thanks
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Today was like Christmas - by kbarnes12 - 06-29-2012, 01:35 AM
Today was like Christmas - by Chato308 - 06-29-2012, 01:43 AM
Today was like Christmas - by kamrr4437 - 06-29-2012, 02:11 AM
Today was like Christmas - by kbarnes12 - 06-29-2012, 02:32 AM
Today was like Christmas - by KWP - 06-29-2012, 03:45 AM
Today was like Christmas - by txgunner00 - 06-29-2012, 12:28 PM
Today was like Christmas - by davidj - 06-29-2012, 02:47 PM
Today was like Christmas - by txgunner00 - 06-29-2012, 04:12 PM
Today was like Christmas - by kbarnes12 - 06-29-2012, 04:50 PM
Today was like Christmas - by LRRPF52 - 06-29-2012, 07:21 PM
Today was like Christmas - by kbarnes12 - 06-30-2012, 03:06 AM
Today was like Christmas - by Rockdriller - 07-03-2012, 04:59 AM
Today was like Christmas - by kbarnes12 - 07-03-2012, 05:18 AM
Today was like Christmas - by Rockdriller - 07-04-2012, 11:02 AM
Today was like Christmas - by kbarnes12 - 07-04-2012, 01:09 PM
|