07-01-2012, 04:54 PM
LOL...
I guess I don't know how to read instructions. :o Both of my LaRue Tactical unimounts were slightly loose. I failed to tighten the bottom screws completely first, before tightening the upper screws. I noticed this morning at the range that there was some "wiggle" in my NF scope. Didn't bother shooting; just brought her home.
Anyone know offhand what torque value I should set the LaRue screws? (Yes, there is thread locker applied to threads).
At about the same time I started shooting my 7mm Rem Mag, I also purchased the LaRue mounts. Killed a lot of brain cells fretting over this...
I guess I don't know how to read instructions. :o Both of my LaRue Tactical unimounts were slightly loose. I failed to tighten the bottom screws completely first, before tightening the upper screws. I noticed this morning at the range that there was some "wiggle" in my NF scope. Didn't bother shooting; just brought her home.
Anyone know offhand what torque value I should set the LaRue screws? (Yes, there is thread locker applied to threads).
At about the same time I started shooting my 7mm Rem Mag, I also purchased the LaRue mounts. Killed a lot of brain cells fretting over this...

