6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Troubleshooting v
Feed problem

Linear Mode
Feed problem
Drifter Offline
Posting Freak
*****
Posts: 1,685
Threads: 55
Joined: Mar 2011
#7
06-18-2012, 10:45 PM
LRRPF52 Wrote:This is usually a case of shoulders not being bumped back enough when full-length re-sizing your brass.

+1. Die probably needs to be screwed down a little further. But don't get excessive; go ~1/16 turn at a time.
Drifter
Find
Reply


Messages In This Thread
Feed problem - by Pbfreak199 - 06-01-2012, 11:27 PM
Feed problem - by VASCAR2 - 06-02-2012, 05:02 PM
Feed problem - by Pbfreak199 - 06-07-2012, 06:06 PM
Feed problem - by LRRPF52 - 06-07-2012, 10:52 PM
Feed problem - by Pbfreak199 - 06-18-2012, 07:34 PM
Feed problem - by rasp65 - 06-18-2012, 08:47 PM
Feed problem - by Drifter - 06-18-2012, 10:45 PM
Feed problem - by sneaky one - 06-19-2012, 01:55 AM
Feed problem - by Pbfreak199 - 06-19-2012, 05:26 AM
Feed problem - by Mutt - 06-22-2012, 02:34 AM
Feed problem - by txgunner00 - 06-22-2012, 03:23 PM
Feed problem - by sneaky one - 06-22-2012, 11:51 PM
Feed problem - by jkingrph - 08-05-2012, 11:41 PM
Feed problem - by Mav714 - 09-17-2012, 03:13 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)