06-02-2012, 05:02 PM
Just curious if these are factory rounds or reloads. I had a problem loading where I seated the bullets to long and cartridges were failing to chamber (hitting rifling). It is also possible not to set your sizing die low enough and the shoulder doesn't get pushed back far enough. If you don't have a cartridge gauge see if your cartridge will easily fall out of the chamber when the muzzle is raised. Before I got my gauges I'd pull my bolt and check my reloads in my chamber for fit. The cases where I seated the bullets to long I had to push out with a cleaning rod.
If your using factory ammo and the rounds come out of the chamber easily I'd check the extractor for a burr. There have reports of out of spec ejectors or a need to trim a coil or to off the ejector spring.
Your situation doesn't sound like a mag problem but I'd sure try a different magazine.
If your using factory ammo and the rounds come out of the chamber easily I'd check the extractor for a burr. There have reports of out of spec ejectors or a need to trim a coil or to off the ejector spring.
Your situation doesn't sound like a mag problem but I'd sure try a different magazine.