06-02-2012, 05:05 AM
My Grendel was doing the exact same thing, so I wouldn't buy anything or change anything until the new J&P spring is out i In the rifle and tested out. It's too easy to forget what was in it last and exactly where you left off. Just wait until you have the spring and try it out before youchange anything else. Mine would stove pipe sometimes and then bit feed at all or out would work perfectly, then mess up all over again. A new magazine wouldn't hurt, but just remember to try the old one after the new spring us in and your trying everything out. Good luck, and I look forward to hearing what happens.
Once I've saved up enough money and sold a few uppers that I've been building, I'm going to buy one of those new encapsulated buffer springs from J&P to try in my suppressed 300 Blackout, that's suppose to make it run really quiet and work better too. But it costs about $120.00 If I remember correctly.?!
See Ya
Eric
Once I've saved up enough money and sold a few uppers that I've been building, I'm going to buy one of those new encapsulated buffer springs from J&P to try in my suppressed 300 Blackout, that's suppose to make it run really quiet and work better too. But it costs about $120.00 If I remember correctly.?!
See Ya
Eric