01-26-2024, 03:59 AM
I am very hesitant to lap or bed with a receiver that I had to heat to get the barrel to fit, most of the grease I put on the extension was squeezed out it was so tight and there is not removing the barrel without a heat gun, a wooden dowel and a deadblow hammer. I was told by SOLGW that the tight fight and use of a heat gun to fit the barrel was done for a snugger fit and more likely accurate rifle. If it was an Anderson, or Aero upper receiver I would go to it without a second thought. I will contact SOLGW to get their input before it mess with that fit, but honestly I am more likely to buy a new barrel.