12-18-2023, 05:04 PM
(This post was last modified: 12-18-2023, 06:51 PM by jasper2408.)
Here is how I setup and use QuickLOAD.
Box colors:
Blue boxes: psi value and mv value
Green boxes: changing powder values
Yellow boxes: psi value, case capacity, Weighting Factor
Red boxes: COAL, case length, barrel length
This screen has all of the Barnes data that Barnes says is safe. Hornady case using my value of 35.6gr, 2.235" COAL and 1.506" case length. Before anyone says anything, I did figure it up using 36.5gr and 35.2gr which were the actual user values. I will give those values at the end.
We have a problem. The top blue box is showing red and is over pressure compared to the top yellow box. My opinion is that Barnes says this data is safe so the number that QL spit out for pressure is now just a number and not pressure. I am not going to change anything in QL such as powder or case capacity to get that number down. Barnes says this data is safe so I am saying that the number in the pressure box is safe. This number is the same or close every time I enter this safe Barnes data. I turned the pressure value into just a number that QL spit out and to me this number is safe with this Barnes data only. All the data on the first pic is safe to use according to Barnes and QL.
[url=![[Image: 1st-pic-copy.png]](https://i.ibb.co/pWhLpm3/1st-pic-copy.png)
][/url]
So what I am doing in this pic is inserting the number that was in the red box and using it to replace the number in the top yellow box. Sometimes you have to use a number that is 1 number over the value so that it will stop being red. It is now just a number that is the ceiling that I can't go over.
[url=![[Image: 2nd-pic-copy.png]](https://i.ibb.co/mzSmnBK/2nd-pic-copy.png)
][/url]
Box colors:
Blue boxes: psi value and mv value
Green boxes: changing powder values
Yellow boxes: psi value, case capacity, Weighting Factor
Red boxes: COAL, case length, barrel length
This screen has all of the Barnes data that Barnes says is safe. Hornady case using my value of 35.6gr, 2.235" COAL and 1.506" case length. Before anyone says anything, I did figure it up using 36.5gr and 35.2gr which were the actual user values. I will give those values at the end.
We have a problem. The top blue box is showing red and is over pressure compared to the top yellow box. My opinion is that Barnes says this data is safe so the number that QL spit out for pressure is now just a number and not pressure. I am not going to change anything in QL such as powder or case capacity to get that number down. Barnes says this data is safe so I am saying that the number in the pressure box is safe. This number is the same or close every time I enter this safe Barnes data. I turned the pressure value into just a number that QL spit out and to me this number is safe with this Barnes data only. All the data on the first pic is safe to use according to Barnes and QL.
[url=
][/url]So what I am doing in this pic is inserting the number that was in the red box and using it to replace the number in the top yellow box. Sometimes you have to use a number that is 1 number over the value so that it will stop being red. It is now just a number that is the ceiling that I can't go over.
[url=
][/url]