11-14-2023, 02:19 AM
lazyengineer Wrote:Does that actually work? Not being sparky, just wondering if the experimental error of that is enough to tell 1:8 vs 1:8.2,since everyone always says there are manufacturing aspects and its super common for a twist rate to be slower than specified (which I have no idea why that would be true ...)
On the few occasions I've done it, it works. Watch as is slowly moves in a circle and mark the points with a black texta.
As for seeing the difference between 8 and 8.2 I don't know, but a jammed tight patch does not slip so I don't see why not.