09-02-2023, 09:09 PM
(This post was last modified: 09-03-2023, 07:45 PM by Tyrone Slothrop.)
I've been reloading for a lot of years but I'm new to the 6.5G.
I bought a couple of Amend 2 poly mags to round out my build. Turns out cartridges loaded to the spec 2.26" can not be properly loaded into the magazine. If I seat them to 2.21" they function fine. Maybe it is an overabundance of caution, but I wanted to check with you experts before I ramp the pressure up on an already high-pressure cartridge. Am I approaching any kind of borderline here?
Loads are 120gr PPU HPBT, Starline brass, 29gr CFE 223 and 29.5gr CFE 223, Winchester WSR primers.
(Edited to reflect correct powder name)
I bought a couple of Amend 2 poly mags to round out my build. Turns out cartridges loaded to the spec 2.26" can not be properly loaded into the magazine. If I seat them to 2.21" they function fine. Maybe it is an overabundance of caution, but I wanted to check with you experts before I ramp the pressure up on an already high-pressure cartridge. Am I approaching any kind of borderline here?
Loads are 120gr PPU HPBT, Starline brass, 29gr CFE 223 and 29.5gr CFE 223, Winchester WSR primers.
(Edited to reflect correct powder name)