The stock fit is near perfect as far as I could tell, I paid attention to the action as I tightened the screws and it settled evenly no binding that I could detect.
The CZ dbm conversion is great. It looks so much better, you know it's not going to break if you overtighten the action screws, ammo feeds smoothly from the metal mags and they accommodate a longer C.O.L as well.
CZ would have a home run with these if they just offered a better stock and metal bottom metal. They're such nice rifles but they're like a Cadillac with an aftermarket bolt on spoiler on the trunk and the cheapest tires you can get from Discount Tire.
I also bought a 3d printed single shot SLED for a CZ 527 on ebay. I screwed and epoxied a hunk of aluminum bar stock on it to make it extend down a bit from the mag well and then filed it to match the mag profile. I use it for all of my bench shooting and it works well.
[ATTACH=CONFIG]19870[/ATTACH]
[ATTACH=CONFIG]19871[/ATTACH]
The CZ dbm conversion is great. It looks so much better, you know it's not going to break if you overtighten the action screws, ammo feeds smoothly from the metal mags and they accommodate a longer C.O.L as well.
CZ would have a home run with these if they just offered a better stock and metal bottom metal. They're such nice rifles but they're like a Cadillac with an aftermarket bolt on spoiler on the trunk and the cheapest tires you can get from Discount Tire.
I also bought a 3d printed single shot SLED for a CZ 527 on ebay. I screwed and epoxied a hunk of aluminum bar stock on it to make it extend down a bit from the mag well and then filed it to match the mag profile. I use it for all of my bench shooting and it works well.
[ATTACH=CONFIG]19870[/ATTACH]
[ATTACH=CONFIG]19871[/ATTACH]