07-19-2023, 06:19 PM
eggman918 Wrote:LRRPF52 I had already concluded that I liked only 1 operation per handle stroke, I know that the human/machine interface is important the feedback in keeping things consistent.
Double seating now that you bring it up also makes good sense.
After priming 10 rounds with the hand priming tool I am not too pleased with it just seems subpar thought it might be me I'm gonna see about the RCBS JR. as a dedicated priming station.
To everyone who replied I again want to say Thankyou your responses were exactly what I had hoped to get as the "New Kid" on the shop floor I needed this from the FOG's who have been there and done that, to save me from having to learn it the hard way and the advice will shorten my learning curve.
I loaded 5 .300 BLK's to the starting load data and tested them about 05:30 this morning and all went as it should, but I have a question about velocity variations I got a 30 FPS spread 1,495 to 1,525 with 3 1,505 to 1,509 Book called for 1,516 is that a reasonable spread or is does quality control need to be increased?
Lol. Looking forward to the responses ok this question. Could you provide more details;
Purpose of load
Expected range
Primer
Powder
Brass
Bullet
Load data
Etc