|
Howa 6mm ARC experience
|
06-14-2023, 02:48 AM
Cleaned up bolt face after photos. Felt for burrs on the bolt face on either side of the extractor & indeed this was an issue. Managed to make some progress removing those burrs. Would really like to remove the ejector & extractor to better facilitate a good polish of the bolt face. Unfortunately I do not have a proper punch to remove the retaining pins. GRR
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Howa 6mm ARC experience - by SDguy - 06-01-2023, 11:14 PM
Howa 6mm ARC experience - by Old Bob - 06-02-2023, 02:33 PM
Howa 6mm ARC experience - by SDguy - 06-06-2023, 11:23 PM
Howa 6mm ARC experience - by Harpoon1 - 06-12-2023, 02:44 PM
Howa 6mm ARC experience - by SDguy - 06-13-2023, 11:36 PM
Howa 6mm ARC experience - by Darryle - 06-14-2023, 12:02 AM
Howa 6mm ARC experience - by SDguy - 06-14-2023, 01:40 AM
Howa 6mm ARC experience - by SDguy - 06-14-2023, 01:46 AM
Howa 6mm ARC experience - by SDguy - 06-14-2023, 01:58 AM
Howa 6mm ARC experience - by SDguy - 06-14-2023, 02:48 AM
Howa 6mm ARC experience - by Harpoon1 - 06-14-2023, 03:50 PM
Howa 6mm ARC experience - by Old Bob - 06-14-2023, 06:39 PM
Howa 6mm ARC experience - by SDguy - 06-25-2023, 07:59 PM
|
