6.5 Grendel Forum › INDUSTRY PARTNERS › Rexus Outfitters v
UltraSlim Crush Washer R&D

Linear Mode
UltraSlim Crush Washer R&D
eggman918 Offline
Junior Member
**
Posts: 46
Threads: 7
Joined: Feb 2023
#5
03-18-2023, 02:03 AM
I would think laser cut stainless shim stock would be the most cost effective way to go, 24 TPI is .083" and change so a .020", .040" and a couple of .005" would likely get the job done.
Find
Reply


Messages In This Thread
UltraSlim Crush Washer R&D - by BluntForceTrauma - 03-17-2023, 10:07 PM
UltraSlim Crush Washer R&D - by eggman918 - 03-17-2023, 11:11 PM
UltraSlim Crush Washer R&D - by Csitt - 03-18-2023, 01:07 AM
UltraSlim Crush Washer R&D - by BluntForceTrauma - 03-18-2023, 01:39 AM
UltraSlim Crush Washer R&D - by eggman918 - 03-18-2023, 02:03 AM
UltraSlim Crush Washer R&D - by JASmith - 03-18-2023, 04:09 AM
UltraSlim Crush Washer R&D - by BluntForceTrauma - 03-18-2023, 04:21 AM
UltraSlim Crush Washer R&D - by eggman918 - 03-18-2023, 11:17 AM
UltraSlim Crush Washer R&D - by Old Bob - 03-18-2023, 11:57 AM
UltraSlim Crush Washer R&D - by Csitt - 03-18-2023, 12:59 PM
UltraSlim Crush Washer R&D - by eggman918 - 03-18-2023, 01:05 PM
UltraSlim Crush Washer R&D - by BluntForceTrauma - 03-18-2023, 03:06 PM
UltraSlim Crush Washer R&D - by Klem - 03-18-2023, 09:18 PM
UltraSlim Crush Washer R&D - by BluntForceTrauma - 03-18-2023, 10:56 PM
UltraSlim Crush Washer R&D - by Old Bob - 03-19-2023, 01:05 AM
UltraSlim Crush Washer R&D - by 41bear - 03-26-2023, 09:55 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)