I had a partial case head separation using a 1.8oz buffer
So many new MSR cartridges and barrel suppliers and unspecified feeding cone designs…..An idea is a chamber support gage, similar idea to those used in gunsmithing of 1911’s to ensure any barrel feed ramp work would not lead to unsafe conditions or bulged cases… thoughts? Could be used to confirm support.
Reply


Messages In This Thread
I had a partial case head separation using a 1.8oz buffer - by Sovereign77 - 10-28-2022, 02:10 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)