I had a partial case head separation using a 1.8oz buffer
stonehog Wrote:Here are 3 of the case lengths on cases showing bumps. The last one is the blown case and is the worst of the batch.

[ATTACH=CONFIG]19147[/ATTACH]
[ATTACH=CONFIG]19148[/ATTACH]
[ATTACH=CONFIG]19149[/ATTACH]
These all may have been fine before they failed and deformed. Their added length may just be from the failure...the deformation beyond normal deformation.

On each case, can you please measure that belt depth at the head? Basically from the failure line down to the top of the base. And keep the calipers and measurement visible?
Reply


Messages In This Thread
I had a partial case head separation using a 1.8oz buffer - by DeNinny - 09-28-2022, 08:41 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)