I had a partial case head separation using a 1.8oz buffer
StoneHendge Wrote:Everyone here is neglecting the likelihood of human error in the barrel manufacturing process. Drill the feed cones too deep and kaboom.

That's the first point of my failure model! I have not neglected this...

"...it's a tolerance stacking issue...the barrel feed cone was too long,..."

Edit: To me, in hindsight, and because Bill Alexander expressed it as a necessary design change from the M16 feed cone, I don't understand why he didn't make that a specification. At least create a maximum depth spec. This is in hindsight, but I think it needs a spec.
Reply


Messages In This Thread
I had a partial case head separation using a 1.8oz buffer - by DeNinny - 09-27-2022, 02:50 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)