Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Initial Load Development Lapua Scenar 120 gn and Leverevolution using GRT
#5
I have always noticed GRT tends to run on the conservative side. I have a feeling that around 30 - 30.5 there is another node but I will still stick with that low node. It gets the job intended for done with less wear and tear on the brass and getting to the target a few milliseconds faster would not make that much difference in regards to the wind. If I were shooting to 1000 that would be different. Thanks for the tips though
Reply


Messages In This Thread
Initial Load Development Lapua Scenar 120 gn and Leverevolution using GRT - by SCJim - 08-13-2022, 06:16 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)