montana Wrote:After further review from my 23&P manual, they are torquing the nut properly. The illustration shows the barrel nut being torqued exactly as SOLGW is doing it..
Respectfully, no! They are not! IMO.

This is the proper procedure for using a Torque Wrench!
https://youtu.be/fBjr9-FDWYw
Clearly in the SOL video he is torquing the nut with the Crows Foot Wrench 180 degrees out from the handle ..that is WRONG! It should be at 90 degrees! Period! Not 80 degrees, not 100 degrees but 90 degrees! Apparently, you dont know the proper technique either?
Good Lord!

