05-30-2022, 05:50 PM
Dt219 Wrote:I have seen a few sources talking about full length sizing die setup. Looks like some are set up with a hard press to where the shell holder makes contact with the sizing die for a cam over effect which they claim takes all the play from the press out of it for consistent sizing results no matter how much bumping back of the shoulder occurs. Some even say the amount of push back doesnt matter as long as they are all consistent. All of my dies- redding, hornady Forster, and rcbs in the different calibers I shoot I get .002-.003 shoulder bump pretty consistently but my shell holder does not contact the sizing die on any of them. I dont have any problems either on paper or cycling, be it in my bolt guns or gas guns. Where do yall stand on the subject ? Thanks
I run my Forsters the same way. Runout is consistent.