03-31-2022, 01:52 PM
imaguy3 Wrote:There was no reason to loosen the side screw that held the detent adjustment in. Tighten that back up and I bet your detent would work as it should. As far as thinking your there... you could have been way off, unless you took it all the way out you have no idea where the end was.
Detent worked just fine. Just wasn't as hard to turn with the set screw loosened a 1/4 turn. Set screw was tightened back up before each shot. I went from bottomed out to an inch of adjustment screw sticking out the front of the gas block. It couldn't have been far from falling out and surely was far beyond any restriction of the gas port.