01-23-2022, 11:50 PM
New Build and have only fired 2 rounds so far, just to get a couple of fired cases.
I purchased the Sinclair Bullet Seating Depth Tool to get some measurements of the chamber.
The problem is I can't get the fired brass back in the chamber even when pushing with my finger.
Everything I've read says use a fired case.
What about resizing with out the expander ball?
Will polishing the chamber help with this problem?
I purchased the Sinclair Bullet Seating Depth Tool to get some measurements of the chamber.
The problem is I can't get the fired brass back in the chamber even when pushing with my finger.
Everything I've read says use a fired case.
What about resizing with out the expander ball?
Will polishing the chamber help with this problem?