starting load for BLC-2 and the hornady 140 bthp

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

starting load for BLC-2 and the hornady 140 bthp

65GbySeven Offline

Member

Posts: 161
Threads: 34
Joined: Dec 2018

01-21-2022, 02:34 AM

Not sure if you're using a bolt or gas gun but with a gas you may want to single feed them to extend your COL provided you can measure for it. I used BLC2 with 129 Hornady Interlocks with no pressure signs up to 29.2GR, but that bullet is a full quarter inch shorter. 1.180 vs. 1.420.

Personally I would start at 26.0 and go up .2GR.

Curious how this turns out.

Find

« Next Oldest | Next Newest »

Messages In This Thread

starting load for BLC-2 and the hornady 140 bthp - by pashiner - 01-21-2022, 01:20 AM

starting load for BLC-2 and the hornady 140 bthp - by Sinclair - 01-21-2022, 01:38 AM

starting load for BLC-2 and the hornady 140 bthp - by 65GbySeven - 01-21-2022, 02:34 AM

starting load for BLC-2 and the hornady 140 bthp - by Sinclair - 01-21-2022, 02:41 AM

starting load for BLC-2 and the hornady 140 bthp - by 65GbySeven - 01-21-2022, 03:11 AM

starting load for BLC-2 and the hornady 140 bthp - by pashiner - 01-21-2022, 01:25 PM

starting load for BLC-2 and the hornady 140 bthp - by Cal - 01-21-2022, 04:25 PM

starting load for BLC-2 and the hornady 140 bthp - by pashiner - 01-21-2022, 05:05 PM

starting load for BLC-2 and the hornady 140 bthp - by Cal - 01-21-2022, 05:13 PM