6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Ammunition & Reloading v
Shoulder Bump Gauge Question

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Shoulder Bump Gauge Question
Velocity Offline
Member
***
Posts: 122
Threads: 28
Joined: Mar 2021
#7
01-12-2022, 02:48 PM
Harpoon1

I think I'll keep using the Whidden Gauge and put some oil on the Sinclair and plastic bag it.
Then again I may just put the Sinclair in the lathe and remove some of that deep champer from the face to match the Whidden Gauge.
Find
Reply


Messages In This Thread
Shoulder Bump Gauge Question - by Velocity - 01-11-2022, 05:16 PM
Shoulder Bump Gauge Question - by Harpoon1 - 01-11-2022, 06:06 PM
Shoulder Bump Gauge Question - by Velocity - 01-11-2022, 06:31 PM
Shoulder Bump Gauge Question - by Harpoon1 - 01-11-2022, 07:00 PM
Shoulder Bump Gauge Question - by Dt219 - 01-11-2022, 09:07 PM
Shoulder Bump Gauge Question - by LRRPF52 - 01-12-2022, 03:02 AM
Shoulder Bump Gauge Question - by TR1Hemi - 01-13-2022, 01:08 PM
Shoulder Bump Gauge Question - by Kosh65 - 01-14-2022, 01:01 AM
Shoulder Bump Gauge Question - by TR1Hemi - 01-14-2022, 04:14 AM
Shoulder Bump Gauge Question - by Velocity - 01-16-2022, 03:39 PM
Shoulder Bump Gauge Question - by BowChamp - 01-16-2022, 04:14 PM
Shoulder Bump Gauge Question - by mtnlvr - 01-17-2022, 01:51 AM
Shoulder Bump Gauge Question - by Velocity - 01-18-2022, 12:50 AM
Shoulder Bump Gauge Question - by Harpoon1 - 01-21-2022, 09:34 PM
Shoulder Bump Gauge Question - by Velocity - 01-12-2022, 02:48 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)