12-14-2021, 10:36 PM
Dt219 Wrote:I think I found it. The cross pin for the extractor is drilled about .010 further back than my other bolts. Wont let the extractor latch over the rim.
Dt,
That is interesting.
There was another thread recently on where the extractor sits relative to the bolt face.
https://www.65grendel.com/forum/showthre...post290108
Here is the sentence in the first post, Also, the lower bolt face edge of the extractor is slightly higher than the bolt face, shouldn't it be flush?
The OP is concerned the extractor groove is not level with the bolt face and the way I understand his FTE is the case rim pushes the extractor out and the claw at the end does not engage with the rim. Anyway, it would be because the hole for the extractor is not drilled in exactly the right place for the shape of the extractor.