12-02-2021, 11:15 PM
I checked that tool out... why check the id? I've only ever seen tubes with shoulders on them. Not to mention it doesn't account for different thicknesses of the actual tube. Unless the other end (right side of pic) is for the o.d. of the tube. Just wondering.
Gas key screws are staked so that would be difficult. I doubt 30" lbs would budge the stakes. I could just replace the key but I see no "blow by." I'll check the o.d. of the tube and the i.d. of the key in a few minutes.
Gas key screws are staked so that would be difficult. I doubt 30" lbs would budge the stakes. I could just replace the key but I see no "blow by." I'll check the o.d. of the tube and the i.d. of the key in a few minutes.