|
Timing help
|
10-30-2021, 04:20 PM
Have you checked to see where your brass is ejecting to try and determine if you are over-gassed or not? I also was getting the ejector mark and cleaned my bolt and they seem to have went away. Check to see if your ejector spring is working freely. The plunger should travel below the bolt face.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Timing help - by Pwoller - 10-30-2021, 03:35 AM
Timing help - by grendelnubi - 10-30-2021, 04:20 PM
Timing help - by VASCAR2 - 10-30-2021, 04:45 PM
Timing help - by Pwoller - 10-30-2021, 11:22 PM
Timing help - by VASCAR2 - 10-31-2021, 03:36 AM
Timing help - by Pwoller - 10-31-2021, 01:14 PM
Timing help - by VASCAR2 - 10-31-2021, 03:50 PM
Timing help - by Pwoller - 10-31-2021, 07:40 PM
|
