09-15-2021, 12:28 AM
The hornady black factory 123 is typically seated short enough to chamber IIRC.
If you're mortaring the round back loose, are there land marks on the side of the bullet, like bullet was stuck up into the lands?
If so, then the chamber might be too short, or you possibly have a 0.125" depth bolt face bolt but a 0.139"-type cut barrel chamber.
If you're mortaring the round back loose, are there land marks on the side of the bullet, like bullet was stuck up into the lands?
If so, then the chamber might be too short, or you possibly have a 0.125" depth bolt face bolt but a 0.139"-type cut barrel chamber.
"Down the floor, out the door, Go Brandon Go!!!!!"