Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Gas Block Question
#8
StoneHendge Wrote:Stay away from the JP block. It's a pig, the design leads to carbon build up on the adjustment screw (and hence potential siezure), and if the adjustment screw is still on the side, you may or may not be able to access it through your handguard (unless you have a JP handguard). I personally go with Superlatives. I just put a new barrel on my 6.5 CM. I hadn't touched the adjustment screw in the Superlative block in 2k rounds and I checked it before I pulled it off the old barrel. The 3/32 hex bent slightly at first and then the screw started turning and clicking like it was new. I have owned an SLR.

Edit add: If your looking at the Strike Eagle 1-6, also take a look at the Burris RT 6.

Thanks so much. Will check it out as well, also looking at 1-6x Viper PST Gen 2 as well that's refurbed for around $500. Much better glass (Japanese compared to Strike Eagles Chinese).
Reply


Messages In This Thread
Gas Block Question - by BVickery1974 - 06-11-2021, 10:15 PM
Gas Block Question - by Klem - 06-11-2021, 10:31 PM
Gas Block Question - by BVickery1974 - 06-11-2021, 10:34 PM
Gas Block Question - by Klem - 06-11-2021, 10:52 PM
Gas Block Question - by Lastrites - 06-11-2021, 10:57 PM
Gas Block Question - by BVickery1974 - 06-11-2021, 11:21 PM
Gas Block Question - by StoneHendge - 06-11-2021, 11:28 PM
Gas Block Question - by BVickery1974 - 06-11-2021, 11:46 PM
Gas Block Question - by montana - 06-12-2021, 04:54 AM
Gas Block Question - by Lastrites - 06-12-2021, 10:53 AM
Gas Block Question - by BVickery1974 - 06-12-2021, 08:59 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)