03-24-2021, 03:45 AM
My 2 piece JP gas block screw was inaccessible under the handguard since it's on the side. Never touched it but then again, I never needed to because I ran the same load for years. Now it is completely stuck and can bend a thin allen wrench far more than I thought it could be bent. My two thoughts are soaking it in Boretech Carbon Remover* or putting into the ultrasonic cleaner (I do have Hornady parts cleaning solution). Unsure of either approach since I might end up filling the narrow insides with sludge as it is broken free. Wondering is anyone has tried either method and has been successful.
* Not soliciting cleaning solution recommendations. We all have our favorites.
* Not soliciting cleaning solution recommendations. We all have our favorites.
Let's go Brandon!