02-19-2021, 08:59 PM
TruLbrt Wrote:Tried this for my monster barrel and monster flash suppressor.Yeah that's true. (BTW, I assume those "lbs" are ft-lbs, not inch-lbs.) However, the tool does allow you to go well beyond just "hand tightening" and it's much better than jamming a screwdriver though the prongs to apply torque.
Fits well but short so max torque is low (15lbs) before the flash supressing prongs start to flex. I observed no distortion afterwards.
The Surefire wrench dealie might be better if you're looking to make it tighter. FWIW, my Thorsden tool also works perfectly on my Vietnam era three-prong FS.