Barrel question for the guru's:14.5 project
|
Barrel question for the guru's:14.5 project
|
02-09-2021, 12:34 AM
If you do decide to go the "get 16 now and chop it later" option, just don't get a nitrided barrel, get plain SS. Nitriding is a bear of hardness... not only for the cut-down but also for any threading on the tip. The re-crown wouldn't be nitrided anyway.
"Down the floor, out the door, Go Brandon Go!!!!!"
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Barrel question for the guru's:14.5 project - by lazyengineer - 02-08-2021, 08:06 PM
Barrel question for the guru's:14.5 project - by grayfox - 02-08-2021, 09:01 PM
Barrel question for the guru's:14.5 project - by biodsl - 02-08-2021, 11:41 PM
Barrel question for the guru's:14.5 project - by grayfox - 02-09-2021, 12:34 AM
Barrel question for the guru's:14.5 project - by Lastrites - 02-09-2021, 11:00 AM
Barrel question for the guru's:14.5 project - by lazyengineer - 02-09-2021, 04:19 PM
Barrel question for the guru's:14.5 project - by lazyengineer - 02-09-2021, 04:59 PM
Barrel question for the guru's:14.5 project - by lazyengineer - 03-17-2021, 08:43 PM
|
